Garage Door Repair – How to Troubleshoot and Fix Garage Door Problems on Your Own

Garage doors are something most homeowners use every day without much thought, until they start to malfunction. If your garage door isn’t operating properly, it can be a major inconvenience that makes it difficult to get in and out of your home. It can also be a safety hazard, especially if it isn’t responding to your commands. The good news is that many garage door issues can be resolved with simple troubleshooting and some DIY repair work.

If your garage door isn’t opening or closing, there could be various reasons for it. The springs may be broken, the sensors could be obstructed, or the motor may have burned out. Before calling a professional, you should ensure that nothing is blocking the door and that the remote batteries are in working order.

You should also make sure that the keypad is set up to open the door and that it has been synced with the opener. A quick sync can fix the problem and it only takes minutes to do.

A garage door Garage Door Repair is made of many moving parts, so it’s no wonder that it can produce a lot of noise when it operates. Whether it’s a grinding sound, a rumbling sound, or a popping sound, any unusual noise can be a sign that something is wrong with your garage door. Listen for any unusual sounds, and if you hear one, turn off the opener and visually inspect the door for what is causing it.

The tracks on a garage door can become misaligned over time, and this will cause the rollers to snag. Visually check the track for obstructions, and remove anything that is caught in it. If the track is still not aligned, loosen but do not remove the screws or bolts that hold the tracks to the mounting brackets, and tap them into place with a hammer or rubber mallet. Then, recheck the tracks with a level to make sure that they are aligned correctly.

A malfunctioning sensor can stop the door from closing if it detects an object in its path, and this can be a dangerous situation. Replacing a garage door sensor will typically cost between $150 and $250, including labor.

Over time, the brackets that support the garage door can become loose or damaged. This can cause the door to sag on one side, and you’ll be able to correct this by loosening and then tightening the screws or bolts that secure the brackets to the wall.

If you’re using a pulley system, you should replace the extension springs when they break. This will ensure that you have even tension on both sides of the door, and can help to prevent further problems down the line. To do this, disconnect the cable from the top pulley by unscrewing it and letting it drape down, then disconnect the other end of the cable from the bottom pulley. Unscrew and remove the bolt from the end of the pulley, and then use a wrench to slide out the old pulley and replace it with the new one.

This entry was posted in General. Bookmark the permalink.